![]() ![]() This is the default login for a Linksys router, unless you have manually changed it, then press OK. We will skip the User name field and in the Password field you will type in admin. This will indicate a connection to the router. Next you should see a pop up asking for a username and password.You will need to open a internet browser(Chrome, Firefox, Internet Explorer) and in your address bar remove what address is there and type in 192.168.1.1.Setting up a Linksys for Port Triggering: If you are still at this point still seeing a NAT issue please see our Alternate Method (Port Forwarding). You may need to give the Comtrend a few minutes to save the information and for it to take affect. Port Triggering should now be enabled on the router.You will then enter in the information show in the picture below exactly as shown. To do this you will see two bubbles to select, we need to select Custom Name and then type in Playsation 4 in that field. We now need to place in an Application Name. This is a drop down option under Use Interface. You will need to select the interface of pppoe_eth/ppp0.3. At this point we should be in NAT-Port Triggering.Finally from here you will need to click on Add. Then you will need to click on NAT and then Port Triggering. ![]() ![]() You will need to click on Advanced Setup on the left side of the page. We are going to now setup Port Triggering. At this point we should be logged into the router.NOTE: If the Username and Password do not work, you may also try the following: In the User Name field you will type in user and the Password will also be user. You should see a pop up asking for a username and a password.You will need to open a internet browser(Chrome, Firefox, Internet Explorer) and in your address bar remove what address is there and type in 192.168.1.1. Setting up a Comtrend for Port Triggering: ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |